Your cart is empty.
Your cart is empty.4.0 out of 5 stars
- #136,209 in Electronics (See Top 100 in Electronics)
- #2,611 in Audio & Video Power Cables
Toptekits IEC320 C14 Power Cord Plug Connector.This easy-to-wire connectors allows you to make your own IEC cable connections without soldering.
Brand new and high quality
IEC C14 Male Connector
IEC 320 C14 3Pin Rewirable Connector
Power Supply: AC 250V 10A
Cable Diameter: up to 8mm OD
Color: Black
material:plastic
Package Included:
1 x IEC C14 Male Connector
Customer
Reviewed in Australia on June 13, 2025
Works as Intended
George Colon
Reviewed in the United States on February 7, 2025
Tremendous Quality and very easy to install with wires . Works like a charm..
David Parker
Reviewed in the United States on January 20, 2025
connector comes all apart for easy assembly. The input tube is designed for 18ga cable, but you can leave that tube out and the inner clamp will take 16ga cable
Susan Lempel
Reviewed in the United States on July 9, 2024
Does the job!
MartyQ
Reviewed in the United States on December 24, 2024
Poor quality construction. The center machine bolt & nut work fine to hold the halves together, but the 2 additional screws are apparently for a strain-relief, which was missing. The internal terminals are too small for even medium duty conductors. One must be very careful to ensure the conductors do not short during assembly.
Charles F.
Reviewed in the United States on March 3, 2023
This is a nice connector. It is designed for an 8mm cord. However, if you remove the stress relief insert, you can fit a 10mm cord.
Roy G
Reviewed in the United States on January 2, 2023
This plug is poorly designed and therefore very cumbersome to install wires compared to a Hubbell or other quality connectors.
TheFatElectrician
Reviewed in the United States on November 28, 2020
I bought this end to make a splitter for my “the fog machine” brand fog machine so I can run two machines off one controller. Worked perfect for my setup.
Client d'
Reviewed in Canada on December 31, 2019
Pour faire fonctionner une machine à pop-corn!
X-stream Scientist
Reviewed in the United States on April 26, 2011
Here are the problems with this connector:- It is manufactured from very cheap, thin, and very easy to crack/shatter plastic. When held in my hands, I can easily deform the thin plastic shell by simply squeezing it. The connector would easily allow moisture to enter. Inexpensive, over-the counter IEC cables with molded ends are much stronger and safer.- The strain relief boot is too narrow of a diameter to accommodate many standard 14/3 cables. Not sure why. I thought this was a reasonable spec for most single-device connectors.- The connector is held together by only one flathead screw. Said screw runs through the middle of the connector, forcing a pretty major bend between the strain relief and the ground terminal. Also, since the connector is held together by just one screw, as stated before, there is play in the connector. I.E. it is relatively easy to deform the connector.In conclusion, you are much better off purchasing an over-the-counter molded IEC cable than building one using this connector. I would highly dissuade anyone from using these in a situation where they will be moved, repeatedly plugged/unplugged, or used with devices that could potentially draw more than a couple of amps. To do so would be unnecessarily dangerous.
Recommended Products
