Your cart is empty.
Your cart is empty. Erie Tools Hydraulic Hose 25 FT x 1/2 inch - 1 High Tensile Steel Wire Braids - Hose Only
Erie Tools 25 ft. of hydraulic hose meets or exceeds SAE 100R17 specifications. Hose has 1/2-inch inside diameter. Oil-resistant hose is made of synthetic black rubber with 1 or 2 high tensile steel wire braids. Hose only, no attachments are included.
Construction:
Tube: Oil resistant, synthetic material.
Reinforcement: 1 or 2 high tensile steel wire braid.
Cover: Synthetic black rubber. Oil, water, and abrasion resistant.
Operating Temperatures: -40° F to +212° F
No skiving required.
Specifications:
Length: 25 ft.
1 or 2 High Tensile Steel Wire Braid
Inside Diameter: 1/2 in.
Outside Diameter: 0.8 in.
Water Pressure: 3,000 PSI
Minimum Burst Pressure: 12,000 PSI
Minimum Bend Radius: 3.5 in.
Jeff D.
Reviewed in the United States on May 6, 2019
I broke a hydraulic return line on my skidsteer. The original was stainless steel and had a pin hole. It wasn't a high pressure line but wanted to be overkill. After all there may of been a reason it was stainless in the first place. The original would of taken a lot of time and work to get out so I just cut it and rerouted it with this hose and two clamps on both sides. After an hour of use, everything seems fine but time will tell. Easier and cheaper than replacing the OEM line.
Recommended Products
$183.99
$ 83 .99 $83.99
$36.50
$ 19 .99 $19.99