Your cart is empty.
Your cart is empty.Transom Rubber Savers for Outboard Motor, Boat Motor Support Trailering Motor Locks
Ken
Reviewed in the United States on July 8, 2025
Was a little skeptical when ordering this, but really glad I did. It fits my Yamaha F60 4-Stroke great. It does require you to tilt your motor pretty high but I'll probably take about an inch off so it rides the way I like. It fit the Tilt/Trim ram very well and is made of a hard rubber that will adsorb the shock of trailering. Highly recommend this product.
Leann
Reviewed in the United States on July 1, 2025
This product is SOOOOO much nicer and more convenient than the transom brace that I have. This is one of those products where once you see it you are like why did I wait so long for this!!! For years I have been using the aluminum bar between the trailer and the motor when trailering the boat. Leaves you always wondering if you placed it right, and if a big bounce were to occurred with the bar it could come off and cause all kinds of damage to others and the boat and motor. With this system, there is no worry. It's simply goes on the cylinder rod and is secured it place by motor itself. It's super simple to use with virtually no effort. Because of its size, when removing, it can be kept in the well near the motor mount, so I always know where it is. Again, it's too simple and works really well.
Sam
Reviewed in the United States on June 23, 2025
This seems like an expensive piece of plastic. It works fine, but I only have one. I feel like I should get a second one to balance the load from my Merc engine. I'm uncertain if having just one could cause any damage to the transom due to the pressure being unevenly distributed. Other than that, it's just a simple plastic block. I think that two for $26 would be more reasonable.
Bliz
Reviewed in the United States on May 24, 2025
Very solid. It works great with my 40 hp Yamaha outboard.
Recommended Products
