Your cart is empty.
Your cart is empty.This is an AM/FM/VHF Weather Band Stereo with Di mounting plate for part number MS-RA200.
GN
Reviewed in the United States on October 3, 2023
I don't normally write reviews but felt like I needed to give this product the credit it deserves. The Fusion MS-RA200MP works perfectly with the Fusion MS-RA60 to cover an existing 7" x 2" cut-out. In my research leading up to purchasing this mounting plate it was not exactly clear, and I hope that this feedback helps others.
Sebastian Valls
Reviewed in the United States on October 2, 2023
Fits well
Avid Buyer
Reviewed in the United States on July 26, 2022
As described
Cory
Reviewed in the United States on March 13, 2022
I was a little worried to order this because it doesn't really say if it fits an MS-RA210, but it ended up working great! This is a genuine Fusion brand adapter for a single DIN opening. Just be aware that it doesn't come with screws.
Laura Sutherin
Reviewed in the United States on January 30, 2021
would be better if they didnt predrill holes aliitle trimming and use the back plate for ra70 and it fit covered the old clarion hole best solution i could fine
EricB
Reviewed in the United States on June 24, 2020
It is not the seller’s or manufacturer’s fault, but it does not fit a Fusion MS-RA70, RA70N, or RA70NX as someone had answered in the questions. I ordered after seeing that answer and didn’t look any closer. All is not lost, I used the measurements and 3D printed my own out of white, non-yellowing ASA filament. I noticed an imperfection in my gel coat from a previous single din stereo and made one slightly larger that I haven’t yet installed. Both of my prints are shown in the photos.If you did not know, the screw holes in this piece line up exactly with previous/larger Fusion single din stereos like my old MS-IP600. The opening in the Fusion mounting plate sold her is the correct height, it just isn’t wide enough. You can buy this and cut the hole wider For your RA-70, but it is thin plastic and you would be cutting out the thick area that you need to screw in to. This can be done if you buy longer screws and use the rear mounting bracket that comes with the stereo. See photos to compare the center opening size with my 3D printed piece. My white 3D printed one has the exact RA70 opening taken from the Measurements/specs in the User’s Manual. I also bought 1.5” #8 SS screws and used the rear mounting bracket that came with my RA-70NX in addition to my 3D printed faceplate.
Robert C. Boyer
Reviewed in the United States on September 27, 2015
Makes mounting the stereo easier. I think this is actually meant to cover the hole from an older radio since the Fusion unit is very small.
Chris S.
Reviewed in the United States on July 23, 2015
Perfect fit. Easy installation. If you are upgrading from the old DIN style radio to fusion, buy this! You won't be disappointed. No screws though! Make sure to get some stainless screws and some black auto touch up paint to paint the heads after install.
Recommended Products
