Your cart is empty.
Your cart is empty.4.8 out of 5 stars
- #127 in External Sound Cards
USB external sound card.
Bare board manner, visible material, compact and easy to carry.
USB interface, plug and play, instead of traditional sound card (computer sound card is broken, can be a direct replacement).
Analog audio signals can be output to directly drive headphones or powered speakers.
No drivers in WIN2000, WINXP, WIN2003 system.
Output Input: 3.5mm green headphone jack, 3.5mm microphone jack.
Chip models: CM108 external crystal.
PCB Board Size: 38 * 7mm / 1.5 * 0.28in (L * W ).
A.N.Onymouse
Reviewed in the United States on August 3, 2020
I'm using this to drive an aviation headset with an electret mic. Clear crisp sound, okay speaker volume output but not as much as I'd like. Ended up buying a little pam8406 audio amplifier to see if I can get better volume out of it. Mic is great. Good access to electrical circuitry if you need to connect to it.
BH
Reviewed in the United States on June 18, 2020
Assuming that most buying this little USB sound fob are using for DYI projects - Please keep in mind that you will need a heat gun in order to remove components. Do NOT pry them off as that can remove/break the solder pads, rendering it useless. (Made that mistake, but ordered two of them knowing I might mess up on the first attempt.) Also, use a magnifying glass and a very fine tip soldering pen when adding resistors and transistors.This was used to interface a Baofeng 888s UHF ham radio to a Raspberry Pi3b+.
Yusuf
Reviewed in the United States on November 1, 2020
Noisy recording sound
Recommended Products
