Your cart is empty.
Your cart is empty. Gauge for reset the center of wheel truing stand
Keep your current stand working correctly
Work with YC-512N Truing Stand
Made in Taiwan
C. Chavis
Reviewed in the United States on June 30, 2025
Haven't used the Park one, but have both this one and the Toopre. They both seemingly work fine and swapping between the two, there isn't any noticeable accuracy difference. Using these are as easy as hanging it on the hangers and taking some measurements to adjust the stand and calipers.The cost on this makes it simple enough to recommend, it's a lot cheaper than the alternative. And you can tell by the way it's designed - it's easy to check to make sure it's square with a t-square and taking some measurements to verify it's accuracy.Not sure if I'd call it a negative, but the pegs are square, which doesn't seem to affect use, but I do like that the Toopre one has round pegs.
G.G.Rover
Reviewed in the United States on June 14, 2025
Used in a park tool ts2-2, just gotta be careful when clamping that it stays square. Very light to no pressure, just remove the side to side play, and hold it downward in the stand to keep it square while measuring and adjusting. Flip it around and recheck. Ideally it would have been same width as the hub I was using, as the stand itself must be calibrated for each different hub width and rim diameter. The stand itself is not engineered to stay centered when those change.
RandyM
Reviewed in the United States on April 1, 2024
Not a useful tool.
Recommended Products
$52.87
$ 28 .99 $28.99