Your cart is empty.
Your cart is empty.3.7 out of 5 stars
- #71,647 in Electronics (See Top 100 in Electronics)
- #586 in Car Coaxial Speakers
Parameter：
Impedance: 4Ohm
Power: 3W
Characteristic sensitivity of loudspeaker : 83±3dB
Resonance frequency : 320Hz±20%
Insulation Resistance : 10MΩ
Nominal impedance : 4Ω±15%
Input-power rating : 2W
Rated frequency range : 0-20KHz
Distortion factor : maximum 5%
Diameter: 40mm
Height: 20mm
It will work well for home audio-visual equipment and other HiFi speakers.
It also can be used for Arduino diy Kits.
Package included:
2 x 4Ohm 3W Full Range Audio Speaker
edgepilot615
Reviewed in the United States on June 18, 2025
Lower quality, having some sound issues from the driver. can't handle much power.
SolMan636
Reviewed in the United States on January 6, 2025
My Pop had too much bass and sounded distorted so much some words from Alexa were hard to make out. This speaker fit the hole just fine after I cut out the old on with utility knife and soldered the wires.
Jesse
Reviewed in the United States on July 18, 2023
They sound good for the size and are relatively sturdy. The soldering tabs are a bit fragile but when treated with care they should hold up fine.
Customer 0
Reviewed in the United States on December 25, 2021
Bought these to replace speakers in a bluetooth altec. I am unsure if these speakers are water proof from the front like the altec ones.The magnet in these speakers are smaller than the one altec uses. So I'm disappointed . I hear a slight difference but still bassy enough to match, especially with equalizer.At least it fit snug and was cheaper than most others but it's not for me so...Still, this deserves like a 4.5 star rating. Altec makes it easy to repair right now so yea these were a good replacement but I need a bigger drive/magnet and water proofing from the front but these dam sellers cant always or wont always put such spec details up
Recommended Products
